voltage used is 12 volt
Low voltage warning flow: 15 mA
Alarm tone can be changed with the R7.
Tips Merawat Battery basah
- Keep the electrolyte in the battery between the lower level and upper level lines. Check it at least once a month.
- Short of electrolyte will cause sulfation to the elements and reduce the battery's performance in generating electricity flow.
- Use distilled/demineralized water only for battery filling. Avoid using tap/well/mineral water as they may contain metal ions or organic substances that lower the battery's performance and its life.
- Clean the battery's surface and keep from any electrolyte spill.
- Clean the terminal surface using a little grease/lubrication to prevent from oxidation or fungus.
- Do not connect the positive and negative terminal using a piece of wire as this will damage/terminate the connection between the terminals and elements.
- Make sure the wire connection to the terminals is tight enough. Loose connection causes sparks, it may cause the battery explodes.
- Cover the positive terminal's surface using isolator (plastic/rubber) to avoid short circuit to the vehicles body.
- Cover the battery's surface with plastic/rubber sheet to protect it from dust/dirt blocking the vent holes.
- Check the vent holes periodically. Blocked vent holes may cause the battery expand and eventually will cause explosion or leakage.
Tips Recharge a battery
Quick-charge recharging.
- Make sure the charger is at OFF position
- Attach the clips (red + and black -)
- Connect the charger to the electricity point
- Set the timer
- Set the recharging flow (maximal equivalent to the battery's normal capacity).
- These steps apply only to an emergency condition.
Normal recharging.
- Make sure the charger is at OFF position
- Attach the clips (red + and black -)
- Connect the battery in parallel fashion
- The recharge flow is selected for a battery with small capacity
- Recharge flow volume is 1/10 of normal capacity
- Recharge time: 3 times constant voltage.
After recharging is completed.
- Turn off the charger
- Release the clips on the battery
- Release the wire from the electricity point.
Terima kasih telah membaca artikel tentang Battery indicator di blog Kumpulan Skema Elektronika jika anda ingin menyebar luaskan artikel ini di mohon untuk mencantumkan link sebagai Sumbernya, dan bila artikel ini bermanfaat silakan bookmark halaman ini diwebbroswer anda, dengan cara menekan Ctrl + D pada tombol keyboard anda.